Tuesday, October 12, 2010

Further UFO China sightings close one more airport

A story with a “UFO China” headline seems almost common. It seems like there is one more one each few months. A new sighting has been observed over an airport. Airport security is a top priority for most nations. The international airport was closed for a while after the sighting. Ordinarily, UFO reports are often dismissed out of hand. China has been a hotbed for Unidentified Flying Object sightings over the past year.

UFO sighting happens right before China airport closes

The “UFO China” headline has been seen before, although the most recent one isn’t repetitive. An object was seen within the skies. This had been above Baotou, Inner Mongolia too. Inner Mongolia is technically part of the People’s Republic of China although it is inhabited mostly by Mongolians. An object had been seen near the airport. It could not be identified though. Air traffic had been delayed or rerouted for about an hour. There were crazy lights moving within the sky. The object had been initially seen by a plane approaching the runway, according to ABC. Planes had to be rerouted while flights were notified as the object had been reported to traffic control. An object was on the radar also, says a traffic controllers.

China Unidentified Flying Object reports

Lots of reports have come in from China in the last few months. These have all been about UFO sightings. One more international airport was closed in Hangzhou because of a UFO sighting. This had been at the Xiaoshan Airport. Other provinces in China have had Unidentified Flying Object sighting reports. Even though it might not make sense, numerous of the accounts are denied as it has been shown to be military activities.

Don’t forget these are unidentified

An unknown object isn’t necessarily a UFO. Military testing facilities, such as “Area 51″ in Nevada, have shown UFO accounts for several years.

Articles cited

ABC News

abcnews.go.com/International/fresh-report-ufo-chinas-skies/story?id=11814100 and page=1



No comments:

Post a Comment